Page: <<Previous 1 2 3 4 5 6 7 8 9 10 11 12 Next>>

We're All Cut Up, Let's Assemble...

Let's hope that WE are not all cut up just the wood, please...?

NOTE: Make sure to pre-drill all screw holes before inserting any screw!!!

Take 2 of the 55" pieces and 2 of the 13.5" pieces and attach them like this. They are to be placed about 4" from both ends of the main support beams.

Grab one of the 36" pieces and place it like in this picture. It should be placed 3' 1.5" from the edge of the far end of the main support beam to the inside edge (considering that anything pointing towards the center of the machine is "inside").. If you need more explanation, look at this great schematic with all the lengths you need labeled on it. Also, It should stick out 1' on both sides of the base.

Also, to add support for the "trough" pieces, I added another piece here. This is the third 13.5" piece that you cut earlier. It's outer edge is 16.5" from the end of the the main support beam to its outside edge.

Page: <<Previous 1 2 3 4 5 6 7 8 9 10 11 12 Next>>